VERTEx 60
Large Area VERTEX 60 Formwork System
Easily adaptable system, which solves all requirements for architectural concrete design. VERTEX 60 is applicable in different type of projects and construction sites. From simple straight walls, complicated column cross-section through residential and high-rise construction up to construction of bridges. It can also be used as formwork shutters for single sided or climbing systems. The standard components of the system such as steel waling’s, H20 beams and flange clamps can be assembled in formwork and even customized for a particular project on request.
COST EFFECTIVENESS
VERTEX 60 formwork system:
VERTEX 60 system application:
Large area wall formwork;
Column formwork;
For single sided system;
Bridges construction;
For Climbing system.
Adaptable load-bearing capacity:
Due to its adaptability Vertex 60 can be assembled and customized to withstand almost any pressure of fresh concrete (recommended range is form 30 up to 70 kN/m2);
The most cost-efficient in terms of formwork price and pace of forming is 40 kN/m2 of permitted pressure of fresh concrete.
Cost-effective:
Large-areas of concrete surface can be easily casted;
High number of use cycles means lower follow-up expenses;
Reduction of expenses by means of system adaptability;
High quality of concrete surface minimizes finishing work;
Project-specific adaptation possible, as it can be faced with any type of formwork plywood.
Easy handling and planning:
All the connectors and accessories are easily fixed into the slots and quickly tighten, consequently forming time is efficient and maximized;
Load-bearing capacity of the system can be adjusted by means of H20 beams and steel walings;
Any requirements for architectural concrete design can be met, due to the system adaptability.
Safe use:
Accessories such as — lifting hooks, wall brackets, supporting struts etc. make for save and easier handling of the system.
ADJUSTABLE CIRCULAR SYSTEM
Adjustable circular Formwork RINGFORM
The circular formwork Ringform by Salesbridges is a practical system for forming of smooth and curved walls. Only 6 types of elements are used: 3 sizes in height 1.2/2.4/3.0 m and 2 widths, 2.4 m for inner part of the wall and 2.5 m for outer. The required radius is easily achieved by using adjustable spindles.
Load-bearing capacity
- 50 kN/m2 permitted pressure of fresh concrete
- High quality film faced plywood with thickness of 21 mm. Film weight 240 g/m2
Easy to use
- Having only 6 standard panel provides much easier planning and forming.
- All the connectors and accessories are easily fixed into the slots and quickly tighten, consequently forming time is efficient and maximized.
- No need for extra holes in plywood. The same anchor hole’s used throughout a project.
- Can be easily connected to the framed formwork Varimax.
- Radius can be continuously adjusted from a radius of 3.5 m upward, simply by turning spindles.
Cost-effective:
- The system elements are pre-assembled and are ready for use simply by setting the desired radius with the adjusting spindles;
- Installation of pre-assembled units minimizes use of a crane;
- Smaller quantities are needed, as it adapts effortlessly to any layout;
- High number of use cycles means lower follow-up expenses;
- Reduction of expenses by means of restoration and cleaning possibilities;
- High quality of concrete surface minimize finishing work.
Safe use:
- Accessories such as — bracing platforms, bracing struts etc… make for save and easier handling of the system.
Fast working:
- Radii are set easily—simply by turning spindles;
- Can easily be combined with Varimax, Varimid, Vertex 60;
- There is only one type connection device (Adjustable clamp).
